Preventing Slips and Trips

Why This Matters

Preventing Slips and Trips deserves a specific pre-task check because surface condition, changes in level, poor lighting and obstructions can cause loss of balance with little warning. For this briefing, connect the topic to the exact equipment, work area and conditions the crew will face today, and agree a clear stop-work trigger before the task begins.

Key Points

• Slip and trip incidents occur disproportionately on familiar routes, since familiarity reduces active attention rather than increasing caution
• Wet flooring, loose cords, and uneven surfaces represent the most consistently documented contributing factors across industry incident data
• A brief deliberate pause to visually scan the path ahead prevents substantially more incidents than reliance on reaction time alone

Best Practices

• Clean up spills immediately and clearly mark wet or contaminated areas
• Maintain walkways clear of cords, tools, and staged material at all times
• Use handrails on stairs consistently, not selectively when carrying bulky items
• Exercise heightened footing awareness on uneven, wet, or icy surfaces
• Select footwear appropriate to the specific walking surface conditions encountered
• Report damaged flooring, missing handrails, or inadequate lighting promptly rather than routing around the hazard indefinitely

Scenario & Site Check

Discuss this scenario: A crew is about to start work where preventing slips and trips is relevant, but one condition in the work area has changed since the task was last performed. Ask the team what could make that change important, which control must be verified first, and who has authority to stop the job.

• Field check: walk the travel path and correct spills, uneven surfaces, cables, lighting and footwear issues.
• Evidence: confirm the applicable permit, inspection, label, test result, procedure or equipment status rather than relying only on memory.
• Close-out question: “What would make us stop and reassess this task today?”

Reference Point

Use the current requirement that applies to your site. A useful starting point for Slips Trips Falls is OSHA / NIOSH primary guidance. Company procedures, manufacturer instructions and local law may impose additional or more stringent controls.